MXL V67i Tube
MSRP: $849 Cardioid Condenser Tube Microphone
Description
MXL’s V67i Tube is essentially a tube-amplified version of the V67i. Both mics are dual-capsule, large-diaphragm condensers with a unique “warm/bright” switch to control the selection of the front or rear capsule.
Both capsules measure 32mm (OD), with a 25mm diaphragm. One has a 6-micron Mylar diaphragm; the other has an 8-micron Mylar diaphragm. Both are gold-sputtered and center-terminated.
The two capsules differ primarily in their high-frequency response; the “bright” side has 6dB higher response above about 4kHz.
Capsule selection is confirmed by red LEDs mounted inside the headbasket.
A switch beneath the gold headbasket allows selection of the front or rear; the selection is indicated by a red LED.
The amplifier circuit uses a 12AT7 dual-triode tube.
The V67i Tube ships with a dedicated power supply, a Mogami power cable, a 15' Mogami XLR cable, a foam windscreen, an elastic shockmount (p/n MXL-57), a hard mount (p/n MXL MT-001) and an aluminum flight case.
Permalink: MXL V67i-Tube
The mic was released in 2008.
Specifications
| Pickup Patterns | Pads & Filters |
|---|---|
|
Cardioid
(22 mV/Pa; 20 - 20,000 Hz) |
|
| Capsule Dimensions | Impedance | SPL/Noise |
|---|---|---|
| Diaphragm diameter: 25mm Capsule diameter: 32mm Diaphragm gauge: 6 microns |
200 Ohms (Low) | Max SPL: 150 dB Self-noise: 22.0 dB(A) |
| Weight | Length | Max Diameter | Interface(s) |
|---|---|---|---|
| 680g (23.99oz) | 210mm (8.27'') | 47mm (1.85'') |
|
| Power Specifications |
|---|
|
Did we get anything wrong on this page?
Please let us know!
